Omnitron Systems iConverter RS-422/485 Serial to Fiber Media Converter DB-9 ST Multimode 5km Module Wide Temp - 1 x RS-422/485; 1 x ST Multimode; Internal Module; Lifetime Warranty - RoHS, WEEE Compliance 8780-0-W

The Omnitron iConverter RS422/485 is a managed serial RS-422 and RS-485 to fiber converter that transmits serial protocol over fiber media. Fiber transmission extends serial signals up to 120km, and is immune from electrical and magnetic interference. The RS422/485 is available with a single-mode, multimode or single-fiber transceiver. The serial port interface is available with either a DB-9 female connector or terminal block connector for field wiring. The RS422/485 automatically detects the signal baud rate of connected Full-Duplex serial device, ranging from 110 to 921,600 baud. It also automatically adjusts to changes in the connected device''s Full-Duplex baud rate during operation without reconfiguration or interruption of service. Half-Duplex RS-485 and Full-Duplex RS-485 (sometimes referred to as Multipoint RS-422) operations are supported via a configurable baud rate DIP-switch to match the master/slave communication timing.Supports baud rates ranging from 110 to 921,600 baudSerial interface available as DB-9 or Terminal Block connector for field wiringFeatures built-in configurable terminatorsFeatures configurable baud rate for Half-Duplex RS-485 and Full-Duplex RS-485 operationSupports RTS and CTS controlsSupports Point-to-Point Half and Full-Duplex, Multi- Point Full-Duplex, and either Head, Tail or Mid-PositionFeatures remote Fiber Loopback DIP-switch for easy testing of fiber link, even during serial transmissionManagement is available with the addition of a management module to the chassisModules are hot-swappable in 19-Module, 5-Module, 2-Module or 1-Module chassisLifetime Warranty and free 24/7 Technical Support

Write a review