TRANSITION NETWORKS Point System RS232 Copper to Fiber Media Converter - 1 x DB-9 , 1 x SC Duplex - TAA Compliance CRS2F3114-100

Transition Networks Point System RS232 Copper to Fiber Media Converter - 1 x DB-9 , 1 x SC Duplex - TAA Compliance

Transition Networks'' serial RS232 to Fiber Media Converter allows you to extend the distance between serial connections with the use of fiber optic cable. This full-featured converter transmits the full complement of RS232 flow control/handshaking signals optically and supports full or half-duplex asynchronous data transmission at speeds up to 115Kb/s.The diagnostic features included on this converter make installation easy and intuitive. A DTE/DCE switch eliminates the frustration over selecting the appropriate cable. A loop-back switch allows for complete diagnostic testing prior to system turn-up or during troubleshooting. Unit and Port LEDs allow for quick status information of the converter.

Technical Specifications:
Total Number of Ports: 2
Number of SC Ports: 1
SC Port Type: Duplex
Number of Serial Ports: 1
Media Type Supported: Optical Fiber
Fiber Mode Supported: Single-mode
Maximum Distance Supported: 12.43 Mile
Power Consumption: 5 W
Form Factor: Internal
Height: 3.4"
Width: 3.4"
Depth: 5"
Additional Information:

Switches:

DTE/DCE, Loop-back, Loopback (Local or Remote on copper and fiber)

Supports the following flow control signaling:

DCD - Data Carrier Detect, RXD - Receive Data, TXD - Transmit Data, DTR - Data Terminal Ready, SG - Signal Ground, DSR - Data Set Ready, RTS - Request To Send, CTS - Clear To Send
Compatibility:

Pointy System Chassis

Certifications & Standards: EIA/TIA-574, EIA/TIA RS-232E

Compliance:

CISPR22/EN55022 Class A + EN55024, EN60950 Class A, FCC Class A, CE Mark
Country of Origin: United States

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: