VisionTek PoE Raspberry Pi Hardware Attached on Top Accessory - HAT for Raspberry 3 B+ and 4 - 2.6" Width x 0.7" Depth x 1.5" Height 600000

VisionTek PoE Raspberry Pi Hardware Attached on Top Accessory - HAT for Raspberry 3 B+ and 4 - 2.6" Width x 0.7" Depth x 1.5" Height

Raspberry Pi HAT "Hardware Attached on Top" Accessory Power Over Ethernet in a smaller, more efficient Pi-HAT than the official one from Raspberry Pi. This design fits in the official Pi enclosure and takes up less of the board. This Pi HAT fits Raspberry PI 3 B+ and Raspberry Pi4. Key Features Fits Raspberry Pi 3 B+ and Raspberry Pi 4 (Not Included) Works with an IEEE 802.3af switch or 48v injector (Active PoE Only) Smaller, more space efficient than Official Pi-HAT Optocoupled with flyback topology to prevent shorting the board Fanless Increases efficiency above 90% for DC to DC conversion

Warning: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.

Technical Specifications:
Power Source: DC
Height: 1.5"
Width: 2.6"
Depth: 0.7"
Weight (Approximate): 1 oz
Compatibility: VisionTek Raspberry Devices:

3 B+ , 4

Environmentally Friendly: Yes
Environmental Certification: WEEE
Country of Origin: China

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: